Product Description
NOTE: On some C6 applications there may be a ridge of unmachined material with separate the two OE bushings. This area must be honed down to allow installation.
Tooling Required
E4OD 4R100 Rear Case Bushing
Fits 1989-1994 | Early Style w/ 3-Grooves to Front and No Grooves to the Back
Pack of 4
The OE rear case bushings in Ford E4OD and C6 transmissions tend to wear out prematurely. Bushing failure may be due to lack of lubrication, excessive journal clearance or too much load for a given bearing area. Replace the two OE bushings with Sonnax rear case bushing 36008B or 36008D using the Sonnax installation tool T36008A to draw the replacement bushing into place. Both one-piece replacement bushings are an improvement over the OE two-bushing design because of their increased bearing surface area and superior lubrication characteristics.
Symptoms
- Premature wear & bushing failure
- Inadequate lubrication
Cause
Lack of lubrication or too much load for the bearing area.
Correction
Sonnax one-piece, standard size rear case bushing installation system can replace a worn-out bushing and save expensive cases.
Contents
- Bushing (4)
Specifications
- Bushing Style: Precision
- Material: Steel-backed bimetal
- Width: 1.620"
- Shaft Dia.: 1.470"
- Housing Bore: 1.593"
