Product Description
-
D44001CR (Right, Passenger’s side)
-
Chevy/Jeep spindle bolt pattern accepts “outers” from all open knuckle Chevy and Jeep Dana 44, Dana 30, and 10-bolt front ends to 1986
-
Cast from high strength ductile iron
-
Beefed up with extra material and ribbing
-
Flat tops machined and drilled for high steer arms
-
4th bolt hole for high steer arms increases clamping force and sheer strength (3 hole high steer arms still fit) For 4 hole steering arm distributors click here
-
3/8″ thickness added to flat top of the knuckle for high steer tie rod to leaf spring clearance
-
Cast-in DUAL steering stops eliminate bent stop bolts that can cause u-joint and axle failures
-
Tapered tie rod holes accept factory tie rod ends
-
Tie rod holes can be drilled to accept 3/4″ heim ends
-
Powder coated bright Orange® for long lasting looks
-
Interchangeable with all factory and aftermarket Dana 44 components
-
Fully machined and ready for installation
-
Machined to clear CTM u-joints without removing the grease fittings
-
Tie rod hole is tapered from the top to the bottom
Will fit 10-bolt and early Dana 30 axles with minor modification.
Dealer inquiries welcome. Knuckles for off road use only. -
There is no warranty on this product.
